157bf3fb0c
This driver exposes the data encoded in the "hard_config" flash segment of MikroTik RouterBOARDs devices. It presents the data in a sysfs folder named "hard_config". The WLAN calibration data is available on demand via the 'wlan_data' sysfs file in that folder. This driver permanently allocates a chunk of RAM as large as the "hard_config" MTD partition (typically 4KB), although it is technically possible to operate entirely from the MTD device without using a local buffer (except when requesting WLAN calibration data), at the cost of a performance penalty. This driver does not reuse any of the existing code previously found in routerboot.c. This driver has been successfully tested on BE (ath79) and LE (ipq40xx and ramips) hardware. Tested-by: Roger Pueyo Centelles <roger.pueyo@guifi.net> Tested-by: Baptiste Jonglez <git@bitsofnetworks.org> Tested-by: Tobias Schramm <t.schramm@manjaro.org> Tested-by: Christopher Hill <ch6574@gmail.com> Signed-off-by: Thibaut VARÈNE <hacks@slashdirt.org>
PROJECT OPENWRT
The Source Code of OpenWrt-Lean Modified by CTCGFW
Welcome to our Telegram Group: @ctcgfw_openwrt_discuss.
How to make it
Minimum requirements
Linux with case sensitive
2G DDR2 RAM
2 CPU Cores (AMD64, 1.4Ghz)
25G disk space left
Has access to both ChinaNet & Internet
Install the necessary packages (for Ubuntu user)
sudo apt-get update -y
sudo apt-get full-upgrade -y
sudo apt-get install -y build-essential asciidoc binutils bzip2 gawk gettext git libncurses5-dev libz-dev patch unzip zlib1g-dev lib32gcc1 libc6-dev-i386 subversion flex uglifyjs git-core gcc-multilib g++-multilib p7zip p7zip-full msmtp libssl-dev texinfo libreadline-dev libglib2.0-dev xmlto qemu-utils upx libelf-dev autoconf automake libtool autopoint ccache curl wget vim nano python python3 python-pip python3-pip python-ply python3-ply haveged lrzsz device-tree-compiler scons antlr3 gperf ecj fastjar
For mainland China & Ubuntu(16.04+) user, you may run the following command to setup quickly:
sudo bash -c "bash <(curl -s https://build-scripts.project-openwrt.eu.org/init_build_environment.sh)"
Clone the source
git clone -b openwrt-18.06 --single-branch https://github.com/project-openwrt/openwrt && cd openwrt
./scripts/feeds update -a && ./scripts/feeds install -a
For developer, you may use openwrt-18.06-dev branch instead of openwrt-18.06.
Configure your firmware
make menuconfig
Make it
make -j1 V=s
Tips
You'd better not use root to make it, or you may be not able to use.
Default login address: 192.168.1.1, username is root and password is password.