3198ec5b9d
This commit fixes and cleanups qcom-ipq8064-wg2600hp.dts to improve the
support for WG2600HP.
- Use dt label in qcom-ipq8064.dtsi:
- gmac1
- gmac2
- gsbi4
- gsbi4_serial
- gsbi5
- hs_phy_0
- ss_phy_0
- usb3_0
- usb3_1
- pcie0
- pcie1
- qcom_pinmux
- Fix wrong pcie reset (perst) gpios
- drop reset-gpio and use perst-gpios in qcom-ipq8064.dtsi
- Remove unnecessary dt label from device dts
- flash
- phy0, phy4
- Rename spi-nor node to "flash" from "m25p80"
- Fix qca,ar8327-initvals
- use oem settings
- fix: PAD0_MODE, PAD6_MODE
- drop: PAD5_MODE (unnecessary)
- Move mtd partitions under partitions (fixed-partitions) node
- Specify "firmware" partition format
- WG2600HP uses uImage format (denx,uimage)
- Change failsafe status LED to power_red
Signed-off-by: INAGAKI Hiroshi <musashino.open@gmail.com>
_______ ________ __
| |.-----.-----.-----.| | | |.----.| |_
| - || _ | -__| || | | || _|| _|
|_______|| __|_____|__|__||________||__| |____|
|__| W I R E L E S S F R E E D O M
-----------------------------------------------------
This is the buildsystem for the OpenWrt Linux distribution.
To build your own firmware you need a Linux, BSD or MacOSX system (case
sensitive filesystem required). Cygwin is unsupported because of the lack
of a case sensitive file system.
You need gcc, binutils, bzip2, flex, python, perl, make, find, grep, diff,
unzip, gawk, getopt, subversion, libz-dev and libc headers installed.
1. Run "./scripts/feeds update -a" to obtain all the latest package definitions
defined in feeds.conf / feeds.conf.default
2. Run "./scripts/feeds install -a" to install symlinks for all obtained
packages into package/feeds/
3. Run "make menuconfig" to select your preferred configuration for the
toolchain, target system & firmware packages.
4. Run "make" to build your firmware. This will download all sources, build
the cross-compile toolchain and then cross-compile the Linux kernel & all
chosen applications for your target system.
Sunshine!
Your OpenWrt Community
http://www.openwrt.org